New Picoreplayer is out->V4.0.0 beta 5 + Moode 4.2 install instructions („moslog“)

hi there, 😉
a new picoreplayer is out->V4.0.0 beta 5->https://www.picoreplayer.org

its almost the same; like in this phenomenal 😉 , earlier post-> http://essabre-90xx-rpi.sfb2.com/2018/04/new-picoreplayer-is-out-v3-5-24-march-2018/

this time they have a rpi-kernel bump to Kernel 4.14.56, the DSD(Dop-)-„native patches“ are included, selectable..

tried to use the new „Allo Katana“-overlay here too on an ES9038Q2M->no success/didnt work/squeezelite refuses to start..

use now again (as described in the mentioned, earlier post) the „i-sabre-9023„-overlay, checked „384k“ and „bclk_ratio_int_div“ option, under „Card Control“..

got 32/384 without any problems, same with DSD-„material“->up to 32/352..(see also earlier post)..

but still a little bit „metallic“-sound; as described and still don´t know why..

Volumio“ for example has for my ears (IMO) a far far better sound/tune..

second:

a few days ago, i tried to install Moode 4.2 on a fresh raspian-stretch-lite..i knew there were such commands like „mosbrief,moslog and moslast“ for monitoring the installation progress; but i didn´t know how to use it correctly..

started the installation anyway, but as you see absolutely nothing !! u don´t know if it hangs/or is finished or something and so i had an incomplete installation after all..

so today i had the time to re-test it; in short: place a „ssh“-file in the root of the card (after imaging the raspbian stretch-lite on it); u can now ssh on it..make the commands for the mosbuilding (absolutely fabulous !! article about it in english here->Link and in german here->Link (fabulous !!)

after rebooting the first time (u first have to make a „hard-reset“, means unplug and re-plug the power (else it didnt work !!) u can now ssh on the pi again (while still working/compiling etc..) with now (and thats important too) ssh-login: pi and pass (thats new): moodeaudio

now u can type „moslog“ and can watch the installation progress, wonderfulst !! 😉

(by that i´ve „demolished“ my lovely raspberry zero w ;-( , wrong soldered and so on (but this „soldering“ was, as said, more difficult than on an arduino or esp32-board for example)..

i still want to buy a new ES9038Q2M Green V1.07 and finally some OPA627, but have a small „cash-flow“-problem, „distinguished said“ at present 😉

will post then maybe more again 😉

Schreibe einen Kommentar

Deine E-Mail-Adresse wird nicht veröffentlicht. Erforderliche Felder sind mit * markiert.