Moode V4Beta11 Install script..(+Audiophonics ES9028Q2M Driver Linux-Kernel 4.9.51)

so,
because there are here so many searches concerning „Moode Audio“-image here´s a „install-script“ for an almost automated install->moode-automatic-install
its from the „official“ Moode-/supportforum->http://www.diyaudio.com/forums/pc-based/271811-moode-audio-player-raspberry-pi-1160.html

and there´s also a new „driver“-package for the Audiophonics ES9028Q2M linux-kernel 4.9.51..it came across via the „Volumio“-forum because the hardware-volume wasnt working for the new Volumio-releases..(but this is absolute „Audiophonics ES9028Q2M-related because they implemented this „HW-Volume-control“)..->Q2M_kernel_4-9-51
but another thing is, if i look in the archive there are such „i-sabre-codec.co and i-sabre-k2m.dtbo“ files which can be used for the Q2Ms too, and so somebody have to/could try to use them/modify to take the full advantages (and higher sampling-rates) out of these ES9028Q2M/ES9018K2M-chips..

any experiences/results->please leave a comment here..

Update DIY: STM32F103C8T6 („BLUE PILL“) + ST Link V2

so,
got yesterday my STM32F103C8T6 (earlier post)->diy-stm32f103c8t6-blue-pill-oled-tft-display/
1,55€ (inkl.shipping)->Aliexpress -> Link
first->its smaller than i expected (see 2.picture) and its very „friggling“..

i thought, no problem, i use my Pi, wire it up like in some Youtube-Videos, use the Arduino IDE and begin to upload a sketch etc..
but:Wasn´t“ ; )..got always a „STM32flash -> „Device init failed
(use btw. first my USB-serial adapter with RX,TX and ground->Arduino said:“Device not recognized“)..
googled through a thousand STM32-Arduino-forum/threads, millions of hours, and the final conclusion is:

Buy a ST-Link V2 !! -> 1,68€ Aliexpress -> Link

directly from the beginning (with a STM32F103C8T6)->strongly adviced/recommended from my side here too !! 😉
(hope this will do the trick !! (toi,toi,toi->german phrase)) 😉